Beebeecraft Tutorial On How To Make Lace Bracelet With Hemp Cord
search

Beebeecraft Tutorial On How To Make Lace Bracelet With Hemp Cord

Updated 10/27/20

Beebeecraft Tutorial On How To Make Lace Bracelet With Hemp Cord
Beebeecraft Tutorial On How To Make Lace Bracelet With Hemp Cord

"I believe every girl has a dream of a princess in her heart, so I'm going to teach you how to make a lace bracelet. Through the following tutorial, you can simply make your own lace bracelet. The Lace Bracelet With Hemp Cord made by yourself is very meaningful whether you want to give it to a friend or keep it for yourself. If you want to own your own handicraft, then follow me to learn!"

NotesHere, a beautiful lace bracelet is finished. Have you found that it is particularly easy to do? Do you feel full of girl's heart? There are more beautiful handmade products in the next issue. See you next time


Project TypeMake a Project

Bead TypeCrystal, Pearl, Wire

Time to CompleteIn an evening

Bead Technique UsedChainmail/Wirework

Bead Project TypeBracelet

easy

Materials List

  • 2m×5mm Jute Ribbons with Lace;
  • 4×2mm flat back pearl cabochon;
  • 10~20×7~8×5mm silver terminator;
  • 12×7×3mm silver lobster claw clasp;
  • 4mm silver jump ring;
  • 45~55×3.5mm silver chain;
  • 3.5mm brass rhinestone chain;
  • pliers

Instructions

  1. prepare a jute ribbon with lace that is about the length of your wrist, we need to divide the brass rhinestone chain into several small pieces, and then glue the cut square brass crystal rhinestones to the center of the jute ribbon with lace ;

  2. use glue to glue the flat back pearl cabochon to the jute ribbon with lace, and glue it to the places on both sides of the square brass crystal rhinestone;

  3. use the same method to glue the flat back pearl cabochon and square brass crystal rhinestone all over the jute ribbon with lace;

  4. attach the two terminators to the two ends of the jute ribbon with lace and clamp it with pliers;

  5. prepare a jump ring and a lobster claw clasp and install them to the joint of the terminator;

  6. use pliers to put the jump ring and chain together, and use pliers to put the jump ring and lobster claw clasp together;

  7. install the connected jump ring and chain at the joint of the terminator, install the connected jump ring and lobster claw clasp at the joint of the other terminator;

  8. Choose the size that fits your wrist and fasten the lobster claw clasp to the chain

Leave a Comment

Rate This Project

I have not made this yet so I cannot rate it.

Cancel Reply to Comment

Thanks for your comment. Don't forget to share!

Close

Report Inappropriate Comment

Are you sure you would like to report this comment? It will be flagged for our moderators to take action.

Thank you for taking the time to improve the content on our site.


Join our community of 5 million crafters!

Thank You for Signing Up!
There was an issue signing you up. Please check your email address, and try again.
Close Window