Gorgeous Autumn Sun DIY Bracelet
From the Blogger: "This bracelet uses a porcelain focal from Golem Designs, made in Bulgaria by two artists. The bracelet can easily be modified to take advantage of the myriad of colors available from Golem. With leather remaining popular in the fashion world, this bracelet is sure to be a hit! It can easily be resized to accommodate a wide range of wrist sizes, and, depending on the colorway, could be easily designed for men as well as women."
Project TypeMake a Project
Bead TypeMetal, Miscellaneous
Time to CompleteUnder an hour
Bead Technique UsedStrung
Bead Project TypeBracelet
Materials List
- 19.5 inches 2mm Round Leather Cord - Natural
- 13 inches 2mm Round Leather Cord - Camel
- One Golem Studio Slider Flat 10mm Round Solid - Sunflower
- Two 5mm Single Bar Flat Leather Cord Slider - Antique Brass
- One pair B&B Benbassat 10mm Sunburst Flat Leather Cord Crimp End Cap - Antique Brass
- One Clasp Lobster 15mm - Antique Brass
- One Jump Ring 6mm 21g - Antique Brass
- Two Jump Ring 4mm 21g - Antique Brass
- Super New Glue®
Autumn Sun DIY Bracelet
DIY Bracelet Instructions
-
Use two 4mm jump rings to attach the clasp to one end cap; attach the 6mm jump ring to the other end cap using two 4mm jump rings.
-
Cut the leather into five 6 ½ inch segments and line up with the lighter leather in the middle.
-
Apply a small amount of glue to the end of the leather and insert into the end cap.
-
Use chain nose pliers to flatten the center section of the end cap.
-
Add the sliders as shown.
-
Check the size of the bracelet and trim the ends of the leather if needed before gluing/crimping the other ends of the leather into the end cap